Cisco 642-061 Certification Exam,100% Success Rate Cisco 642-061 Exam Guide Is Your Best Choice

Flydumps Cisco 642-061 exam questions which contain almost 100% correct answers are tested and approved by senior Microsoft lecturers and experts.They have been devoting themselves to providing candidates with the best study materials to make sure what they get are valuable.Get a complete hold on flydumps.com Cisco 642-061 brain dumps on Flydumps, you will pass the exam absolutely.

QUESTION 86
The PVDM slots on the motherboard of the Cisco 2800 and 3800 ISR are used for what purpose?
A. to support the high-performance AIM modules
B. to support the EVM
C. to support the integrated DSPs for voice termination, conferencing and transcoding
D. to support built-in VPN acceleration providing high-performance Crypto offload
E. to support the onboard TDM switch

Correct Answer: C
QUESTION 87
Exhibit: *** MISSING ***
You work as a network administrator at Certkiller .com. You study the exhibit carefully. Given that the
network is running OSPF routing protocol over the WAN, which type of OSPF routing is being used on the
router labeled “Mollie”?

A. virtual link
B. point to point
C. route redistribution
D. point to multipoint

Correct Answer: D
QUESTION 88
Exhibit: *** MISSING ***
You work as a network administrator at Certkiller .com. You study the exhibit carefully. Interface serial 1 is
a 128-kbps Frame Relay connection. What does the command frame-relay adaptive-shaping becn
configure the router to do?

A. allows bursts to 128 kbps and sets the BECN bit when 80 kbps is exceeded
B. sends a frame with the BECN bit set when the committed burst size is exceeded
C. allows bursts to 128 kbps and throttles traffic down to the minCIR value when a frame is received with the BECN bit set
D. allows bursts to 80 kbps and throttles traffic down to the minCIR value when a frame is received with the BECN bit set
E. allows bursts to 80 kbps and sets the BECN bit when 72 kbps is exceeded
Correct Answer: C QUESTION 89
What are three important characteristics of the Cisco Catalyst 2960G-24TC switch? (Choose three.)
A. Each Ethernet 10/100/1000 port supports up to six priority queues each with two drop thresholds.
B. contains 24 Ethernet 10/100/1000 ports and 2 dual-purpose slot
C. provides a maximum forwarding bandwidth of 32 Gbps
D. does not support 802.3af PoE
E. uses the GBIC/SFP form factor for dual-purpose ports

Correct Answer: CDE
QUESTION 90
Your retail customer has 330 branch locations that it wishes to connect via Frame Relay. At the headquarters location there will be two DS-3 Frame Relay circuits, each connected to an ISR 3845 router. Each branch location will have a fractional T1 with a 128-kbps CIR and a PVC mapped to each of the DS-3 circuits. Which two considerations must be addressed for this design? (Choose two.)
A. Additional routers and circuits should be installed at headquarters so that no more than 200 branch locations are mapped to each ISR due to IDB limitations.
B. The CIRs should be reduced so the DS-3 circuits are not oversubscribed.
C. The MTU for the Frame Relay circuits should be set to 4470 to allow the LMI message to include all 330 DLCIs.
D. Frame Relay traffic shaping should be implemented to prevent congestion in the Frame Relay switch.
E. The customer should not run OSPF. Since all branches are connected to the same circuit at headquarters they must be in the same OSPF area, and the number of branches exceeds the design recommendations for routers in an OSPF area.

Correct Answer: CD
QUESTION 91
What three network applications are enabled via Cisco NetFlow? (Choose three.)
A. security analysis
B. network modeling
C. topology mapping
D. quality of service
E. application profiling
F. user profiling

Correct Answer: AEF
QUESTION 92
Exhibit: *** MISSING ***
You work as a network administrator at Certkiller .com. You study the exhibit carefully. Which type of
campus network design would be concerned with these requirements?

A. server farm
B. Layer 2 core
C. enterprise campus
D. Layer 3 backbone

Correct Answer: C
QUESTION 93
Your boss at Certkiller .com, Mrs. Certkiller, is curious about Cisco design. Match the definition with the appropriate design.

A.
B.
C.
D.

Correct Answer:
QUESTION 94
In the Cisco Catalyst 6500-E Series chassis, what are three key chassis specifications? (Choose three.)
A. six- and nine-slot chassis support only 6000-W power supplies
B. supports all existing supervisors, line cards, switch fabrics, and software releases
C. three-slot chassis supports CEF720 line cards
D. requires Cisco IOS 12.2(1)SXD and beyond
E. is backward-compatible with all existing software versions

Correct Answer: BCE
QUESTION 95
Which three of these are features of the Cisco Catalyst 4900 Series Switches? (Choose three.)
A. stackable
B. Layer 2 through Layer 7 switching capabilities
C. redundant power supplies
D. fixed configuration
E. Power over Ethernet
F. one RU
Correct Answer: CDF QUESTION 96
What are three important characteristics of the Cisco Catalyst C3750G-48PS switch? (Choose three.)
A. provides GBIC support for a single 10 Gigabit Ethernet interface
B. can group up to nine switches into a single stack using Cisco StackWise
C. contains 48 Ethernet 10/100/1000 ports and 4 dual-purpose slots
D. provides a maximum forwarding bandwidth of 32 Gbps
E. supports class 2, 802.3af PoE up to a maximum of 24 ports

Correct Answer: BCD
QUESTION 97
A client wants to install a secured repeater access point to extend its network to an area that has no wired network access. After properly configuring the repeater access point for Cisco LEAP, what two configurations must the customer implement in order for the secured repeater access point to connect and send data? (Choose two.)
A. Configure the username and password to be used by the repeater when authenticating to the root access point.
B. Configure the repeater access point to transmit and receive on a nonoverlapping channel from the root access point.
C. Configure the root access point as “bridge mode,” so it transmits the dynamic key when a repeater access point requests it.
D. Configure the repeater access point for Network EAP authentication.
E. Configure the repeater access point as “bridge mode” so it requests the dynamic key from the root access point.

Correct Answer: AD
QUESTION 98
Which two standards enable the PVDM module on the ISR to provide secure communications with IP Phones? (Choose all that apply.)
A. RSA signature
B. AES encryption
C. RUDP
D. SRTP
E. MD5 hash
F. IPSec

Correct Answer: BDE
QUESTION 99
Certkiller .com wishes to eliminate the expense of distributing training videotapes to each location but is worried about bandwidth consumption affecting critical business applications. Which network module can be added to ISRs to allow the customer to distribute the videos over the WAN with minimal impact on bandwidth?
A. NM-HDV
B. NM-CE-BP-40G
C. NM-16ESW-1GIG
D. NM-CUE-EC
Correct Answer: B
QUESTION 100
Exhibit: You work as a network administrator at Certkiller .com. You study the exhibit carefully. To which type of network does this design principle most likely apply?

A. small
B. medium
C. service provider
D. large

Correct Answer: D
Worried about Cisco 642-061 pass results? Adopt most reliable way of exam preparation that is Cisco 642-061 Questions & Answers with explanations to get reliable Cisco 642-061 pass result.Flydumps definitely guarantees it!